Option 1: Install Angle Adjustment Bolt
Option 2: Install Lock Bolt
Tighten All Nuts
© Copyright, Proxicast LLC. All rights reserved.
Contents may vary depending on model - Specifications subject to change without notice.
www.proxicast.com
To position the pole at an arbitrary angle,
install the 2 short adjustment bolts from
the inside of the pole and through the
curved slot.
To position the pole at 0˚ or ±45˚, insert
the long lock bolt through one of the 3
pre-set position holes in the base.
Prior to installing antennas or other devices
on the pole, check all bolts and tighten all nuts.
4
5
6
Rev 20211129
To Previous Page
Loading...