- 12 -
Translation of the Original
Operating Instructions
Proxxon - Micromot 230/E
Dear customer!
Always keep these operating instructions and
the enclosed safety guidelines within reach.
Only use this device with exact knowledge of
it and comply with the instructions and safety
guidelines!
This is necessary to ensure safe operation and,
secondly, it facilitates familiarisation with the
device and its functions.
Proxxon assumes no liability for the safe
function of the device in the case of:
• handling that does not comply with normal
intended use,
• use for other purposes not mentioned in
the manual,
• incorrectly executed repairs,
• failure to heed safety instructions,
• external infl uences for which the
manufacturer is not responsible.
We recommend using PROXXON original spare
parts for all repair and maintenance work.
Repairs should only be performed by qualifi ed
skilled personnel!
Please note: All information contained in these
operating instructions - especially the technical
data - corresponds to the status at the time of
printing.
We reserve the right to make further developments
in the interest of technical progress. We wish
you every success with the device.
Warning!
Read all safety warnings and instructions.
Failure to follow all safety warnings and instruc-
tions listed below may result in elec-
tric shock, fi re and/or serious injury.
Keep all safety warnings and Instructions for
the future !
Safety instructions for all operations
Safety warnings common for grinding, san-
ding, wire brushing, polishing, carving or
abrasive cutting-off operations:
a) This power tool is intended to function as a
grinder, sander, wire brush, polisher, carving
or cut-off tool. Read all safety warnings, in-
structions, illustrations and specifi cations
provided with this power tool. Failure to follow
all instructions listed below may result in electric
shock, fi re and/or serious injury.
b) Do not use accessories which are not speci-
fi cally designed and recommended by the tool
manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe
operation.
c) The rated speed of the grinding acces-
sories must be at least equal to the ma-
ximum speed marked on the power tool.
Grinding accessories running faster than
their rated speed can break and fl y apart.
d) The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool. Incorrectly sized ac-
cessories cannot be adequately controlled.
e) The arbour size of wheels, sanding drums
or any other accessory must properly fi t the
spindle or collet of the power tool. Accessories
that do not match the mounting hardware of the
power tool will run out of balance, vibrate exces-
sively and may cause loss of control.
f) Mandrel mounted wheels, sanding drums,
cutters or other accessories must be fully in-
serted into the collet or chuck. If the mandrel
is insuffi ciently held and/or the overhang of the
wheel is too long, the mounted wheel may be-
come loose and be ejected at high velocity.
g) Do not use a damaged accessory. Before
each use inspect the accessory such as ab-
rasive wheels for chips and cracks, sanding
GB
To Next Page
Loading...
