PS Audio Dectet Power Center - Getting Started; Power Cables

4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com
Getting Started
Getting Started 1
©2012 PS Audio International Inc. All rights reserved.
®
Owner’s Reference Dectet Power Center
Once your new Power Center is unpacked, you’ll need to nd a convenient place to set it.
There are several ways to mount the Power Center: on the oor, on a shelf, or in a rack.
If your equipment is located a long distance from the Power Center, it is preferable to use a long,
heavy gauge shielded power cable between the wall AC receptacle and the Power Center, rather
than long individual power cables between the equipment and the Power Center.
The Power Center can benet from aftermarket isolation devices such as cones, spikes and
Sorbothane pads.
Once you have chosen the location for the Power Center you can use the supplied AC power cord
to connect it to the AC wall receptacle or you can use an aftermarket power cord and receptacle.
We strongly recommend the use of a PS Audio PerfectWave Power™ AC cable and a PS
Power Port™ AC receptacle to feed the Power Center electricity. While the supplied power
cable is adequate for the task, it is not going to provide the best performance. Choosing any
PerfectWave Power cable will make a signicant performance improvement over the stock
power cable.
We do not recommend connecting any other power conditioning product before the Dectet
Power Center.
Isolation
Power Cables
Location
Mounting
Conditioners