PS Audio NuWave DSD - Do I need to install a software driver for the USB?; What voltages can the NuWave DSD run on?

®
Questions And Answers
©2015 PS Audio Inc. All rights reserved.
Owner’s Reference NuWave DSD
Questions and Answers
4826 Sterling Drive, Boulder, CO 80301 15-074-01-1
PH: 720.406.8946 www.psaudio.com Rev A
(<+06
7:
You do not need to install a driver for the USB connection if you have a Mac but it will be necessary if
you have a Windows based machine.
The Windows USB driver is available for download on the PS Audio website www.psaudio.com under
our Resources/Download section. Unzip the fi le and then install the driver. Make sure the NuWave
DSD is on and then connect a USB cable between the NuWave DSD and the computer which should
indicate it recognizes a new device has been installed and should install the appropriate software
drivers to operate it. You can then choose to play music to the PS Audio NuWave DSD. Detailed
instructions are available in this manual’s Troubleshooting section.
The NuWave DSD is specifi c to your country’s voltage. Do not use the NuWave DSD on a voltage
higher than it is rated for. For instance, do not take a 120 volt rated NuWave DSD and attempt to use
it in a 230 volt country. Failure to observe this cautionary note will void your warranty and may damage
the DAC. If you need to operate the NuWave DSD at a voltage other than the voltage it was designed
for, contact your dealer, distributor or the factory.
What voltages can
the NuWave DSD
run on?
Do I need to install
a software driver
for the USB?
6