PSI Woodworking Products
CSC3000C Barracuda 2 Key Chuck
4-Jaw Self-Centering Key Chuck System
Product CSC3000C The Ideal Chuck for Midi and Full Size Woodworking Lathes
Warranty
Thank you for purchasing one of PSI’s growing family of woodworking products. The #CSC3000C is engineered and manufactured to the highest standards
of quality.You will find this product an essential accessory to your workshop.
This product is warranted against defects in material and workmanship for a period of two years for all components. This warranty applies to the
original purchaser of the product and is limited to the repair and/or replacement of the product, or its parts at the discretion of PSI Woodworking
Products. Excluded are parts which have been misused, abused, altered, or consumed by normal operation of the chuck.Also excluded are direct or
consequential damages to persons, properties, or materials.Your invoice serves as proof of purchase and must be referenced to authorize any warranty
repair. Call your PSI dealer for proper authorization.
Safety Instructions for Chuck System #CSC3000C
1. Do not wear gloves or loose clothing when turning
2. Do not wrap any strip sandpaper or clothing around your hands or fingers when sanding or turning.
3. Use proper eye protection when turning.
4. Check your wood for splits, weakness or cracking prior to mounting on the chuck.
5. Confirm that the wood is tightly gripped before turning your chuck under power.
6. Rotate the chuck manually prior to starting your lathe to confirm proper clearance.
7.Always check and re-tighten after any problem or catch.
8. Use appropriate speeds as referenced in instructions.
9.Always turn with sharp lathe chisels.
10. Capture fine particles from the air with a dust collector.
Package Contents
D
A
C
F
E
B
I
G
H
2
J
A. CSC3000C Barracuda 2 Key Chuck
B. Key tightening wrench
C. Hex wrench (removes jaws)
D. 1 set (4 pieces) of #2 round jaws (pre-mounted to chuck)
E. Screw chuck
F. 3/4" x 16tpi adapter
G. CJAW1 - #1 step jaws
H. CJAW3 - #3 wide jaws
I. CJAWPC - extended pin jaws
J. Blow-molded case
To Next Page
Need help?
General