Required Accessories:
• 1-5/8” Forstner Bit #FB158
• 1-1/16” Forstner Bit #FB1-116
• 9” Forstner Bit Extension #FEX9
• 3 Jaw Drill Chuck (#TM32 series)
• HD Live Center (60°)
• 1” Jam Chuck #CJAM1
• 7mm Drill Bit #PK-7MM
Required Wood Blanks: (see Diagram A)
• Base Blank: 2-1/2” Min Square x (see below sizes)
Be sure both surfaces are cut to 90°
• Head Blank: 2-1/16” Long
Boring the Blanks: (see Diagram A)
Base:
• Mark the center on both ends of the blank. On one
end drill a 1-5/8” dia. hole 1/2” deep.
• Follow with a 1-1/16” bit. Use the point of the previ-
ous hole as a guide. For better results, bore the hole
from both ends of the blank but not necessary.
Head:
• Locate and mark the center of the blank. Bore
a 7mm hole through the blank.
Kit Item #: Mechanism Length: Base Blank Sizes:
• #PKGRIND706: 6” 4-3/8”
• #PKGRIND708: 8” 6-3/8”
• #PKGRIND710: 10” 8-1/4”
• #PKGRIND712: 12” 10-1/2”
#PKGRIND7XX
PSI Woodworking Products
Professional Stainless Steel
Peppermill Kit
Kit Features:
• Traditional Styling
• Stainless Steel Components
• Adjustable Grind
• Available in 4 sizes
DIAGRAM A
BLANK DIMENSIONS & BORING
**Take out (s) where appropriate**
**Take out (2/3 pcs) where appropriate**
Head Blank
7mm Hole
1-1/16”
Hole
1-1/16”
Tenon
1-9/16”
2-1/16”
1/2”
1-5/8”
1-2”
2-1/2” Min
Base Blank
PKGRIND706 • PKGRIND708 • PKGRIND710 • PKGRIND712
To Next Page
Need help?
General