PT W41062 - Specifications; Safety Guidelines and Definitions

1 6
Specifications are subject to change without notice.
SPECIFICATIONS
Max. Capacity:.........................................................................24,000 lbs.
Working Range:...............................................0 to 35-3/4 in. (0-910 mm)
Stroke:................................................................................ 7 in. (180 mm)
Bed Width:........................................................................20 in. (510 mm)
This instruction manual is intended for your benefit. Please read and follow the safety, installation, maintenance and troubleshooting
steps described within to ensure your safety and satisfaction. The contents of this instruction manual are based upon the latest
product information available at the time of publication. The manufacturer reserves the right to make product changes at any time
without notice.
SAFETY GUIDELINES / DEFINITIONS

WARNING: Read and understand this entire instruction manual before attempting to assemble, install, operate or maintain
this product. Failure to comply with the instructions may result in serious personal injury and/or property damage!
The following signal words are used to emphasize safety warnings that must be followed when using this product:

DANGER: Indicates an imminently hazardous situation
that, if not avoided, WILL result in death or serious injury.

WARNING: Indicates a potentially hazardous situation that,
if not avoided, COULD result in death or serious injury.

CAUTION: Indicates a potentially hazardous situation that,
if not avoided, MAY result in minor or moderate injury.

NOTE: Indicates important information, which if not
followed, MAY cause damage to equipment.
UNPACKING AND INSPECTION
After opening the carton, unpack your new product and related parts and accessories. Please
inspect it carefully for any damage that may have occurred during transit. Please check it against
the photograph on carton. If any parts are missing, please call customer service at 1-800-426-1262
between 6 a.m. and 5 p.m. Pacific time.

WARNING: DO NOT operate this product if damaged during shipment, handling or misuse.
Do not operate the product until the parts have been replaced or the fault rectified. Failure to do
so may result in serious personal injury or property damage. All damaged parts must be repaired
or replaced as needed prior to operating this product. Check to see that all nuts, bolts and fittings
are secure before putting this product into service.
If you have any questions, or require assistance with damaged or missing parts, please contact
our customer service department at 1-800-426-1262. Please have the serial number, model
number, and date of purchase available for reference when calling.
1. If you detect anything that may indicate imminent structure failure, stop using
the press immediately and inspect it thoroughly
2. Use this press for the purpose for which it is intended. Do not use it for any
other purpose it is not designed to perform.
3. DO NOT allow untrained persons to operate the press.
4. Removeillttingclothing.Removeties,watches,ringsandotherloose
jewelry, and contain long hair.
5. Wear ANSI approved impact safety goggles, full-face impact safety shield
and heavy-duty work gloves when operating the press.
6.
Keep proper balance and footing, do not overreach and wear nonskid footwear.

WARNING! Ensure that you read, understand and apply the
safety instructions and warnings before use.