3
1. Insert 2 D cell batteries (not included), follow the directions in regards to
polarity (+ -). The positive ends should go in first towards the output hose.
Reinstall switch end cap.
2. Immerse the impeller or suction end of the pump into the liquid
you’re pumping from.
3. Insert the discharge hose into the receiving container, this is where
you’re pumping into.
4. Press the switch to the on position. The switch is located on
the battery end cap.
5. Fill your receiving container to the desired level, be cautious not to overfill.
6. Press the switch to the off position when complete.
INSTRUCTIONS
To Previous Page
Loading...
