EC1309V2
User Guide 2 Remote Control
10
Step 1
Hold down
Study
on the TV study keypad on your STB
remote control for 3 seconds until the indicator next to the
Power
key on the TV study keypad is steady on.
Your STB remote control enters the study mode.
Step 2
Hold down
Power
on the TV study keypad on your STB
remote control for 1 second.
The indicator blinks, which indicates that your STB remote
control is ready for receiving a signal.
Step 3
Aim the emission port of your TV remote control at the
emission port of your STB remote control, and hold down
Power on your TV remote control for 3 seconds to send a
signal.
The distance between the two ports must be within 3 cm.
z
If the indicator quickly blinks three times and then is steady on,
your STB remote control has received the signal and the study of
the Power key function is complete.
z
If the indicator does not respond in the preceding way, your STB
remote control has failed to receive the signal. Repeat steps 2 and
3.
To Next Page
Loading...