PTM SPIRIT - User Manual

Questions and Answers

A
Anthony AlexanderJul 26, 2025
What to do if PTM SPIRIT have paper feed problems with double feeds?
- L
  Lauren HaasJul 27, 2025
  If your PTM Folding Machines are experiencing double feeds, try these steps: 1. Turn the Feed Gauge Adjustment Screw ¼ turn counter-clockwise. 2. Try running the forms again. 3. If the problem persists: a. Try another ¼ turn on the Feed Gauge Adjustment Screw. b. Try reducing the size of the paper stack on the Feed Table. c. Try resetting the Feed Gauge.
T
Tiffany SnyderJul 31, 2025
What to do if my PTM Folding Machines SPIRIT won’t run?
- J
  Joshua OlsenJul 31, 2025
  If your PTM SPIRIT Folding Machine won’t run, try the following: 1. Check that the SPIRIT Power Switch Breaker, located by the power plug, is not in the tripped (out) position. If it is, press it in. If the breaker button will not stay pressed in, wait a minute and try again. 2. Check that the Access Panel on the side cover opposite the control panel is properly in place. 3. Make sure the power switch by the power cord is in the On position. 4. Double-check that the power cord is properly connected to the machine and an appropriate socket. 5. Check that the wall socket which the machine is connected to is functioning properly.
A
Aaron BradleyAug 6, 2025
What to do if PTM SPIRIT paper won’t feed?
- G
  gbrownAug 6, 2025
  If your PTM Folding Machine paper won’t feed, you can try reducing the size of the paper stack on the Feed Table or try resetting the Feed Gauge.
J
John FergusonAug 10, 2025
How to fix a bad fold on PTM SPIRIT?
- K
  Kathy DavisAug 10, 2025
  To correct a bad fold on PTM Folding Machines, check both fold plates and make sure that both paper stops are square. Improperly set Feed Table Paper Guides or Fold Plates can cause this issue.
H
hernandezterryAug 16, 2025
Why is the form buckled in my PTM Folding Machines?
- E
  Eric KelleyAug 16, 2025
  A buckled form in your PTM Folding Machines is caused by a wrong fold plate setting. Check both fold plates and ensure they are set to the correct mark on the scale.
J
Jennifer MooneyAug 21, 2025
How to resolve double feed issue on PTM SPIRIT?
- M
  michellemooreAug 21, 2025
  To resolve a double feed issue on PTM Folding Machines, adjust the feed gauge by turning the feed gauge adjust screw ¼ turn counter-clockwise. This issue may be happening because of a bad feed gauge setting or too much paper on the feed table.