Puky CRUSADER - Page 20

20
Safety checklist
Saddle
Saddle cannot be rotated (12 Nm)* 
Saddle post cannot be rotated (5-8 Nm)* 
Minimum insertion depth marking observed 
Balls of feet reach the ground 
Handlebars/stem (models with shaft stem)
Handlebar shaft tube secured and
cannot be rotated (15 Nm)* 
Minimum insertion depth marking observed 
Handlebars cannot be rotated in stem
(10 Nm)* 
Handles cannot be rotated, upright
seating position 
Handlebars/stem (models with ahead stem)
Stem cannot be rotated on steerer tube
(5-6 Nm)* 
Handlebars cannot be rotated in stem
(5-6 Nm)* 
Handles cannot be rotated,
upright seating position 
Handbrakes
Brake lever cannot be rotated (5 Nm)*,
easily accessible 
Functions perfectly 
Brake pad clean, grease-free,
positioned correctly 
Back pedal brake
Function checked 
Chain
Chain tension is OK
(play approximately 1.5 cm) 
Sufficient lubrication 
Chain guard is complete 
Tyres
Sufficient tread/air pressure (air pressure
to be maintained is on the tyre) 
Wheels
Axle nuts firmly tightened
(VR 15 Nm, HR 20 Nm)* 
Aligned 
Spokes evenly tightened 
Pedals
Securely and correctly mounted
(check L/R) 
Rotate easily 
Bell
Clear ring, easy to reach 
Headlamps
Securely mounted and correctly set/
correctly functioning 
Dynamo
Assembly: Direction of operation,
easy to operate, play-free/moves easily 
Good ground contact, connection
clean and firm 
Rear light
Securely mounted and correctly
set/correctly functioning 
(*Torques of screws in Newton metres)