www.PyleUSA.com
2
Read all documentations carefully before operating the equipment.
Retain this manual for future reference.
Congratulations for purchasing the PSPVC6 6 Channel High Power Stereo Speaker
Selector. It lets you connect up to six separate pairs of speakers to your stereo
receiver/amplier. The control center is especially convenient if you have speaker
sets in dierent rooms and want to turn them on and o independently. You can
enjoy the convenience and exibility of listening to multiple speaker pairs
simultaneously.
The control center lets you use one to six sets of speakers at a time, and is designed
to operate with a stereo receiver/amplier that has a maximum of 100 watts per
channel, and with speaker systems that have a minimum impedance of 8 ohms (see
"Impedance Chart" on page 4)
PREPARATIONS
• Use the PYLE PRO Speaker Selectors only with ampliers rated at 100 watts per
channel or less.
• Your PYLE PRO Speaker Selector is designed to accept any size cable up to 14 gauge
non-terminated speaker wire. If you're using non-terminated speaker wire, do not
use any speaker wire that is larger than 14 gauge. The lower the gauge number, the
larger the cable (e.g., 12 gauge is larger in actual physical size than 14 gauge).
• Do not hook the outputs of one selector into the inputs of another speaker
selector together.
• Before you connect the AC power source, make sure you set ALL speakers ON/OFF
to OFF
• Left and right "commons" are isolated to work with all types of ampliers
• Auto transformer impedance protection.
To Next Page
Loading...