Pullman M7P - Switching off the Appliance

NOTE: To prevent the detergent pump
from breaking, it is recommended that you
stop its operation, pushing the relative
switch, when dosing has not occurred for
several minutes.
NOTE: When the recovery tank is full,
noise increases and the appliance does
not suction; therefore, switch it off and
empty the tank as described in the
relevant paragraphs.
Switching off the appliance
- Press the switches (24 and 25 Fig.13) to “0”
to switch off the appliance; the lamps on the
switches will go out.
- Remove the plug (23 Fig.12) from the electrical
socket.
- Wind up the cable (33 Fig.17) and hook it onto
its housing (34 Fig.17).
10