Cleaning the detergent suction filter
If you note that the detergent is not being
suctioned properly, check and clean the suction
filter located inside the detergent tank.
- Using a screw driver, loosen the suction cap
(39 Fig.26) and remove it from the tank with the
relative suction hose.
- Remove the filter (40 Fig.26) and wash it under
running water; if it is too clogged it should be
replaced.
- Reassemble all of the parts performing these
operations in the reverse order.
Replacing the floor nozzle squeegee
(if present)
If when washing the floors the washing liquid
is not suctioned properly and the floor or
carpet remains wet, check the condition of the
squeegee (41 Fig.27).
If the squeegee is worn or damaged replace it
by slipping the squeegee and its bristles off the
nozzle as shown in figure 27.
12
To Next Page
Loading...
Need help?
General