Pulsar 135 LS - Periodic Maintenance Information; Drive Chain Cleaning; Method of O-ring Chain Lubrication

Periodic Maintenance Information
Drive chain must be cleaned & lubricated as
per periodic maintenance schedule.
a. Drive chain (Non O-ring type)
• Non O-ring type chain should be removed &
cleaned by Nylon brush & Kerosene or in
Chain Cleaning Machine.
• It should be lubricated by SAE 90 grade oil.
b. Drive chain (O-ring type)
• ‘O’ rings must always be kept wet for best
performance hence lubricate every 500 Kms
• O-ring chain lubrication can easily be done
by owners using Bajaj ‘Chain Lube Spray
Can’ available with Bajaj dealers.
Method of O-ring Chain Lubrication :
• Place the bike on centre stand.
• Clean the chain by using lint free cloth (If
excessive mud / slush found approach Bajaj
Service Center for proper cleaning)
• Shake the can vigorously by holding
vertically upright till the noise of steel ball
inside heard uniformly.
• Hold spray can at the back of rear sprocket
with extension tube nose at 5~10 cm.
• Rotate the wheel in reverse direction &
spray the lube on middle portion of the
chain up to full length of the chain.
Drive
Chain
Cleaning
Drive
Chain
Lubrication
26