Pulsar APS Battery Charger - Battery Charging; LED Indicator

Battery Charging
1.
Install the rechargeable battery (not included) (1) along the guides
until stop into the charger's (4) slot.
2.
Point А on the battery and point B on the charger should match.
3.
You can charge two batteries at the same time – a second slot is
designed for this purpose.
4.
Connect the plug of the USB cable (7) to the port (5) of the charger (4).
5.
Connect the second plug of the USB cable (7) to the USB port on the
mains charger (3).
6.
Plug the mains charger (3)into a socket 100-240V(6).
7.
LED indicator (2) will show battery charge status (see the table).
(2) LED Indicator* Battery charge status
Battery charge from 0 to 10%.
Charger not connected to the
mains power supply