Pulsar DTS-i 180 UG III - Page 19

Dealer Development Center
38
Dealer Development Center
37
Crankshaft Bearing Extractor
Drawing No.:
37 1001 14
Application :
To remove bearing from crankshaft
Output Sprocket Holder
Drawing No.:
37 1030 53
Application :
To hold the output sprocket while
removing sprocket bolt
Bearing Driver Set
Drawing No.:
Application :
Common bearing driver set for fitting
and removing bearings from
crankcase.
37 1030 61
Pulsar DTS-i UG-III-180cc Training NotesPulsar DTS-i UG-III-180cc Training Notes
Chassis
Fork oil seal fitment punch
Drawing No.:
37 0040 03
Application :
To fit fork oil seal on outer pipe
Rear Shock absorber adjuster
Drawing No.:
37 00DH 14
Application :
For adjusting the notch position of
RSA to achieve hard or soft rear
suspension
Fork Inner & Outer Tube Extractor
Drawing No.:
74 9310 15
Application :
Used for removing front fork inner
tube from outer tube.
Special ToolsSpecial Tools