Pulsar PCE6200 - Unpacking and Initial Setup; Important Note on Initial Setup; Operating Instructions; Check Oil Level

TO EXTEND THE LIFE OF YOUR AIR TOOLS AND EQUIPMENT, it is recom-
PHQGHGWRLQVWDOODQRLOHUDQGZDWHU¿OWHULQVHULHVZLWKWKH $LU2XWSXW/LQHRIWKH
Air Compressor.
OPERATING INSTRUCTIONS
NOTE:)RUDGGLWLRQDOUHIHUHQFHVWRWKHSDUWVOLVWHGEHORwUHIHUWRWKHAssembly
Diagrams on pages 9, and 10.
To Check The Oil Level:
1. 7KH2LO:LQGRZ%LVXVHGWRGHWHUPLQHLIRLOLVQHHGHG 7KHRLOOHYHOVKRXOG
DOZD\VEHDWWKHPD[LPXPOHYHOUHGOLQHRQWKH2LO:LQGRZ
(See Figure C,
and
Assy. Diagram B.)
UNPACKING
:KHQXQSDFNLQJFKHFNWRPDNHVXUHDOOWKHSDUWVVKRZQRQWKH Parts Lists on
pages 9, and 10 DUHLQFOXGHG
IMPORTANT! 7KLVFRPSUHVVRULVVKLSSHGZLWKWKHRLO¿OOSOXJUHPRYHGDQGZLWKRXW
oil. 7KHRLO¿OOSOXJLVDWWDFKHGWRWKHSRZHUFRUGDVDUHPLQGHUWRDGGRLOWRWKH
FUDQNFDVH $GGRLOWRWKHSURSHUOHYHODVH[SODLQHGEHORZDQGVHFXUHWKHRLO¿OO
SOXJEHIRUHXVH
5
2. If necessary, add a premium quality, 30-weight, non-detergent compressor oil
into the Oil Fill Hole until the level of oil reaches the maximum level as indicated
on the Oil Window (20B).
The optimal capacity of the oil reservoir is 30 ounces.
'RQRWRYHU¿OO. Then thread the Breather V
alve back into the Oil Fill Hole, being
careful not to strip the plastic threads. (See Figure C, and
Assy. Diagram B.)
To Turn The Air Compressor On:
1. Check to make sure the Water Drain Valve (10A) is fully closed.
2. Turn the Air Flow Valve (6A) to its “OFF” position.
3. Connect the air hose (not provided) to the Air Flow Valve (6A) of the Air Com-
pressor.
Then, connect the other end of the air hose to the pneumatic tool (not
provided) that is to be used.
4. Note:
Always plug the Power Cord of the Air Compressor into a 1
15 V~
electrical source (±10% maximum variation).
5.
Rotate the “ON/OFF” Power Switch (1A) to the horizontal position to turn the Air
Compressor on
. (Rotate the “ON/OFF” Power Switch (1A) to the vertical position
to turn the
Air Compressor off.)
6. $OORZVXI¿FLHQWWLPHIRUWKH Tank Pressure Gauge (4A) to indicate 80 PSI
before
using the
Air Compressor.
7. Turn the Air Flow Valve (6A) to its “ON” position to allow air to the pneumatic tool.
FIGURE C
Breather Valve (14B)
Oil Window (20B)
Front Cover (18B)
6