EasyManua.ls Logo

Pulsar PTG3506 - Assembly Instructions; Operating Instructions

Pulsar PTG3506
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 7
OPERATING INSTRUCTIONS
NOTE: This machine is only intended for homeowners and non-commercial users to split firewood as detailed in the instructions and not for any other
purpose.
NOTE: Ensure the power supply is not connected while preparing the log splitter for use.
WARNING: Read and thoroughly understand all instructions and safety information before operating
this log splitter. Failure to do so may cause serious injury or death. Do not allow anyone to operate this
log splitter who has not read this manual. As with all power equipment, a log splitter can be dangerous
if assembled or used improperly. Do not operate this log splitter if you have doubts or questions
concerning safe operation. Call our customer service department at 866-591-8921 to address these
concerns.
ASSEMBLY INSTRUCTIONS
NOTE: This log splitter was completely assembled at the factory. The product has been filled with hydraulic oil at the factory. Refer to the photo and
parts list should it become necessary to disassemble the unit for repair or replacement of parts.
Remove the log splitter from the shipping container. Inspect it for shipping damage. If anything is damaged, contact your dealer or delivering
carrier.
Preparation
1
2
3
4
1 Hydraulic Control Lever
2 Push Plate
3 Work Table Guards
4 Wedge
5 Bleed Screw
6 Fluid Drain Knob w/ Dipstick
7 Lift Handles
8 Motor Housing
9 Circuit Breaker
10 Power Cord
11 ON/OFF Push Button
12 Rear Wheels
6
7
8
9
10
11
12
5
Front View