Pump fails to produce pressure or
pressure is inconsistent
1. Water supply is restricted
2. Water not turned on full power
3. Nozzle is clogged
4. Spray gun leaks
5. Air in line
6. Inlet hose screen is clogged
7. Water supply is over 100° F
8. Pump is faulty
1. Inspect garden hose for kinks or
leaks. Make sure you are using a
large enough garden hose (Min.
¾ inch diameter)
2. Open water source all the way.
3. Clean nozzle
4. Check spray gun connection or
replace spray gun
5. Squeeze trigger handle to
remove air
6. Clean inlet
7. Use cool water supply
8. Contact service center
TROUBLESHOOTING
25
PROBLEM CAUSE SOLUTION
To Next Page
Loading...
