Pulsar XT - Pulsar XT Installation - Steps 8-10; Connect APP Connector; Mount Pulsar XT Module; Reconnect Battery

12
Pulsar XT Installation Cont’d
STEP 8 - Route the APP (Accelerator Pedal Position) connector
over to the throttle pedal. Disconnect the factory APP connector
(located above the accelerator pedal) by sliding the locking tab
towards the rear of the vehicle. As the lock tab slides out, the
connector will slowly slide up and release. Connect both sides into
the Pulsar XT harness.
STEP 9 - Connect the
Pulsar XT module into the
Pulsar XT Connector and
mount it behind the lower
dash panel and secure it to
the dashboard brace.
STEP 10 - Reinstall the lower dash panel and reconnect the
negative terminal on the battery
Brace