Need help?Do you have a question about the Pulsar XT and is the answer not in the manual?
General| Brand | Pulsar |
|---|---|
| Model | XT |
| Category | Motherboard |
| Language | English |
Defines WARNING, CAUTION, NOTICE, and NOTE terms used in the manual for safety and product care.
Explains emissions compliance and the purpose of included stickers for regulatory purposes.
Lists the components and parts included with the Pulsar XT harness and module for installation.
Lists the tools necessary for the installation process of the Pulsar XT.
Instructions to disconnect the negative battery terminal to prevent trouble codes during installation.
Instructions for removing two 7mm bolts at the bottom of the lower dash panel as part of installation.
Guidance on carefully pulling the lower dash panel, noting plastic clip locations.
Instructions to use a trim tool to access the CAN junction box by working around clips.
How to route the CAN connector to the junction box on the driver's side of the dashboard.
Instructions to replace the lighting switch panel after connecting the CAN connector.
Connects the 10-amp leaded fuse to the 12V Power Wire and installs it into fuse location F33.
Routes the APP connector and connects it to the Pulsar XT harness at the throttle pedal.
Connects the Pulsar XT module into the harness and mounts it behind the dash panel.
Reinstall the lower dash panel and reconnect the negative terminal on the battery.
Explains how to control Pulsar XT using cruise control buttons when cruise control is off.
Steps to set up pedal sensitivity levels for Dash Option A, focusing on menu navigation.
Instructions for Dash Option B to navigate menus and select audio for sensitivity level display.
How to change pedal sensitivity using steering wheel controls for both Dash Options.
To Next Page