Pulse Shower Spas 1056-BN User Manual

3
Installation Instructions
Step 1
Step 2
Step 1
Step 2
Step 2
Step 1
Step 3
1
2
Remove existing shower arm and showerhead.
Step 1: Slide escutcheon (3) onto nipple. Step 2: Place plumbers tape (9)
on nipple threads. Step 3: Insert nipple into existing plumbing and
thread to secure. TIP: Use wrench to secure arm and place in
leveled vertical position.
Thread showerhead (1) onto shower arm (2).
3
Tape
Glue
Back of handheld holder
Tape
Glue
Back of handheld holder
Step 2
Step 1
Step 3
6
5
Once handshower holder (8) is secure, insert rubber washer (11) into
both ends of hose (6). Connect hex head end to swivel joint (5) and
tapered end to handshower (7). Place the tapered end of the hose into
the handshower holder (8).
Finished product.
Apply glue (10) to the handshower holder (8) as indicated and add tape
(included) to secure onto wall. Let it cure for 48 hours for complete result.
Handshower holder is
tapered. Assure larger
opening is upright.
4
TIP

Pulse Shower Spas 1056-BN Specifications

General

Brand	Pulse Shower Spas
Model	1056-BN
Category	Plumbing Product
Language	English