Pulse Shower Spas Bali 1050 User Manual

5
Assembly
After unpacking your ShowerSpa, some assembly is required prior to installation.
Shower Arm Assembly
 1. OnthebackoftheShowerSpanearthetop,unscrewthehosettingfromthesafetyinsert(19)andretainrubberwasher.
Remove the safety insert and discard with plastic nut (18).
2. Place escutcheon (2) over threaded end of shower arm (3) and insert through opening. Use stainless nut (6) to secure
shower arm to ShowerSpa. Then secure both set screws (10) located on the stainless nut.
 3. Attachhosettingtoshowerarm(3)ensuringtherubberwasherisstillinhosetting.Donotover-tighten.
Handshower Holder Assembly
NOTE— The handshower holder (11) is directional and must be installed so the set screw (4) is facing down in order for the tapered
endofthehosetotproperly.
1. Use 4mm allen wrench to remove allen bolt (12) from handshower holder (11) and retain lock washer (13). Insert bolt through
lock washer, then opening on side of ShowerSpa. Tighten bolt to holder while adjusting its’ position (we recommend a slight
forward angle).
2. Secure set screw (10) on bottom side of holder to lock in place.
After ShowerSpa is mounted to the wall
Handshower Assembly
1. Insert washer (7) into hexagon shaped end of handshower hose (8) and attach to threaded outlet on bottom of ShowerSpa. Do
not over-tighten.
2. Insert washer (7) into tapered end of handshower hose (8) and attach to handshower (9). Insert handshower into hanger.
3. Check that rubber screen washer (4) is in showerhead (5) and screw showerhead onto the shower arm (3).

Pulse Shower Spas Bali 1050 Specifications

General

Brand	Pulse Shower Spas
Model	Bali 1050
Category	Bathroom Fixtures
Language	English