Pumpables GENIE ADVANCED - Pausing and Resuming Pumping; Adjusting Settings in Pumping Modes

Changing settings in letdown mode
0 1
00:07
VACUUM
In letdown mode you can change the vacuum level only.
Increase the vacuum level with the button and decrease it with the button.
Changing settings in expression mode
0 1
00:07
0 1
CYCLEVACUUM
In expression mode you can adjust both vacuum level and cycle speed. There are
3 cycle speeds available on each vacuum level.
Press the settings button to toggle between vacuum level and cycle speed.
Increase the vacuum or cycle level with the button and decrease it with
the button.
CYCLE
VACUUM
Press the power button to pause pumping during a session. Press the power
button again to resume pumping. If no buttons are pressed, the pump turns off
after 1 minute.
Mode icon blinks when pumping is paused.
Pause pumping during a session
03
02:00
02
CYCLEVACUUM
15