PumpSpy PS2000 User Manual

© PumpSpy Technology, LLC Questions? Email Tech Support: support@pumpspy.com
IMPORTANT!
READ ALL INSTRUCTIONS CONTAINED IN THIS MANUAL BEFORE USING THIS PRODUCT.
Save these instructions for future reference. Failure to read and follow the warnings and instructions
within this instruction manual could result in property damage, serious injury or death.
INSTALLATION AND OPERATING INSTRUCTIONS
ELECTRONICS AND PUMP COMPONENTS ASSEMBLED IN THE USA
MONITORING SOFTWARE AND TECHNOLOGY MADE IN THE USA
12 VDC Sump Pump
System Solid State Pump Controller
Power Supply Requirements 12 VDC
Motor Brushless DC
AMP Rating 18 Amps
Temperature Rating 40°F to 120°F
Discharge 1 1/2” NPT
MAX Flow 3000 GPH
Power Supply Requirements 120 VAC, 60 Hz,
15 AMP
Electrical Ratings 12Amps @ 120 VAC;
18 Amps @ 12 VDC
Relative Humidity 0 to 80%
Storage Temperature 0° to 70°C
Operating Temperature 0° to 50°C
SPECIFICATIONS
PumpSpy
™
PS2000
PumpSpy Technology | support@PumpSpy.com
34000 Lear Industrial Parkway, Avon, OH 44011
®
PUMP
SPY
The PumpSpy System requires a 12V Deep Cycle Battery (not included), 40 amp/hr
minimum, 75 amp/hr or higher recommended. SLA/AGM Battery strongly recommended.
WIFI CONNECTED BATTERY BACKUP
SUMP PUMP & MONITORING SYSTEM
24/7 AUTOMATED REMOTE SUMP PUMP MONITORING

PumpSpy PS2000 Specifications

General

Brand	PumpSpy
Model	PS2000
Category	Water Pump
Language	English

Summary

Specifications

12VDC Sump Pump Specifications

Solid State Pump Controller Specifications

Safety First!

General Electrical Shock Warnings

Provides critical safety warnings to prevent electric shock, including grounding, disconnections, and proper handling of cords.

Explosion Hazard Warnings

Alerts users about risks of explosion, prohibiting the pumping of flammable liquids or use in explosive atmospheres.

Potable Water Usage Disclaimer

Installation - Method I

Pre-Installation Safety and Checks

Emphasizes turning off main pump power, electrical safety, using rigid PVC pipe, and checking existing AC pump.

Method I: Separate Discharge Line Setup

Installation - Method 2

Method 2: Connecting to Existing Discharge Line

Critical Check Valve & Float Sensor Placement

Stresses check valve placement below Y-fitting and correct float sensor positioning for pump operation.

Connecting the PumpSpy Controller

Controller Wiring and Battery Installation

Details connecting the controller to the pumps, switches, and the 12V battery, ensuring correct polarity.

System Initialization and Testing

Connecting to WiFi and Monitoring Service

Activating WiFi Connectivity