Product configuration and parameters
Rated voltage:
120V/60Hz
3
Rated power:
65W
Material quality:
ABS
Maintenance
Always turn off the power to the unit by pressing the Power button
(5) before
performing any maintenance operations. You can clean the product body with a
slightly damp cloth.
Filter replacement
The recommended filter change frequency will vary depending on the duration
of use and the operating environment. The corresponding indicator will
illuminate when the filter needs to be replaced.
Storage
When not using the purifier for a long time, store it in a dry, cool place.
Troubleshooting
Do not disassemble the machine yourself; improper repair may cause danger to the user and
could void the warranty!
Before contacting the after-sales service center, please check the following
troubleshooting table:
Malfunction
Examination
Approach
Will not start
Is the power plugged in?
Plug in the power supply at the correct
voltage.
Are the indicators not lit?
Plug in the power supply at the correct
voltage.
Is there a power outage?
Press the switch button to select the function.
Is back cover snaped in?
Device is available when power is restored.
Airflow is greatly
weaker than
before
Does the filter need to
be replaced?
Clean the pre-filter monthly by vacuuming it
clean or removing it to clean with soap and
water. Make sure it is COMPLETELY dry
before reattaching to the HEPA filter.
Check if the filter has reached the
replacement
cycle and replace the filter if
necessary.
There is odor
at the air
outlet
Does the filter need to
be replaced?
Fan speed cannot
be changed
automatically
Is it manual mode?
Choose the right mode of operation.
*
It is important that the pre-filter is cleaned monthly.
Note:
*The H13 HEPA filter cannot be cleaned or reused. Do not wash them.
*To replace the filter in sequence, please refer to “Before Use”. “First-time use of the
filter to remove the filter and replace the filter after the filter has expired”.
Filter
Operating
Frequency
Pre-filter,
Anti-bacteria cloth,
H13 HEPA filter.
Clean
Replace
Monthly
Every 2 Years
(or 17,500 run hours)
IMPORTANT: Do not use any abrasive material to avoid damaging the surface
of the device.
To Next Page
Loading...