Version 1.0 8.05.2007
Unit 1 Grange Business Park,
Fedamore,
Co. Limerick
Tel: 061 390 000
Fax: 061 390 020
Web: www.pet.ie
User Guide Lines For
TH9800 Programmable Thermostats
The following is a user guide for the TH 9800 Programmable Thermostats and
should be used in conjunction with the manufactures user instructions.
Setting time and day
1. Press the “day and time” Button
2. Press the “+ or –“ to select day
3. Press the “day and time” Button again
4. Press the “+ or –“ to select hour
5. Press the “day and Time” Button again
6. Press the “+ or –“ to select minute
7. Press “Set and Return” when finished
Setting of Programs
1. Press and Hold “Set and Return” and “Prog W-Day” when you see the time flashing then press
“+ or –“to set the time.
2. Press “Prog w-day” again. When you see temperature flashing Press “+ or –“ to set desired
temperature
3. Continue these procedures until entire weekday settings have been programmed.
Press “set and return” at any time to return to the normal programming
4. To set weekends repeat the above process buy substituting “Prog W-Day” for “Prog Sat” or
“Prog Sun”
Note: The thermostat is theoretically never actually off, each programme P1, P2 etc is the start of the
next time block. But you can use the temperature setting to realistically turn it off.
To Next Page
Need help?
General