PURE ChargePAK - User Manual

To Next Page

Portal > FAQs > All Other Radios > Fitting a Pure ChargePAK

Fitting a Pure ChargePAK

Pure Support - UK - 2015-05-27 - in All Other Radios

Add a ChargePAK rechargeable battery pack and listen to your Pure radio wherever you go.

ChargePAKs are much more economical than regular batteries and signiﬁcantly kinder to

the environment, reducing the quantity of batteries that end up in landﬁll sites

Easy to install – can be ﬁtted in seconds

Easy to use – just ﬁt and forget

Charges inside the radio, no separate charging unit required

Increased battery life per charge over standard rechargeable batteries

Replaces the need for throwaway alkaline batteries

Provides many hours of wireless listening

This guide will show you how to ﬁt your Pure ChargePAK to your Pure radio. Before you

start ensure the following is in place:

Ensure your ChargePAK is unpacked and ready to install.

Ensure you have your Pure radio with you and disconnected from the mains power supply.

Installing your ChargePAK – C6L, E1, B1

The ChargePAK plugs in to a socket in the battery compartment of the PURE radio. The

battery plug is made up of a number of pins that will correspond to the socket in the radio.

The pin numbers vary depending on the type of ChargePAK you are using. The example

pictures below show the 4pin C6L ChargePAK connectors.

Need help?

Do you have a question about the PURE ChargePAK and is the answer not in the manual?

Summary

Instructions for installing the C6L, E1, B1 ChargePAK into the radio's battery compartment.

Guide for installing ChargePAK A1 and D1 models using the green tab connector.

Steps to fit ChargePAK F1 by aligning its metal contacts with the radio's contacts.

Instructions for installing the C6L, E1, B1 ChargePAK into the radio's battery compartment.

Guide for installing ChargePAK A1 and D1 models using the green tab connector.

Steps to fit ChargePAK F1 by aligning its metal contacts with the radio's contacts.

General