PURE Fun Seesaw - Assembly Steps; Seat, Handlebar, and Main Bar Assembly

STEP1:SeatandHandlebarAssembly
A. Attach the Seats:
Secure a plastic seat (N) onto each end of the Side Bars (K) using 4x M6 25mm Bolts (E), 8x M6 Washers
(F), 4x Lock Washers (G), and 4x Nuts (P), as shown in Figure 1. Make sure that the Lock Washer is resting
against each Nut.
B. Attach the Handlebars:
Afx the a Handlebar (M) to each of the Side Bars (K) using 2x M6 45mm Bolts, 4x M6 Washers (F), 2x Lock
Washers (G), and 2x Nuts (P) as shown in Figure 2. Make sure that the Lock Washer is resting against each
Nut.
STEP2:MainBarAssembly
A. Attach the Side Bars to the Main Bar:
If not already present, slide a Small Plastic Tube (V) onto the end of each Side Bar (K) you assembled.
Next, slide the bars into the Main Center Bar (H) as shown in Figure 3.
B. Select Side Bar Bolt Formation:
Formation1(Extended,belowleft): Secure with 2x M6 60mm Bolts (B) 4x M6 Washers (F), 2x Lock
washers (G) 1x M6 50mm Bolt (D1), 2x M6 Washers (F), and 1x Lock Washer (G) using the left diagram in
Figure 4.
Formation2(Standard,belowright)): Secure with 2x M6 60mm Bolts (B) 4x M6 Washers (F), 2x Lock
washers (G), using the lower right diagram in Figure 4.
It is recommended that you start off with the bars at equal lengths, and adjust only if necessary due to a
signicant difference in height or weight of the children using this seesaw. If you do not use the D1 bolts, be
certain that you keep these bolts in a safe place in case they are needed in the future.
D1