PURE Jongo S3 Instruction Manual

EN
ChargePAK F1 Safety Instructions
1. Read the instructions for ChargePAK use in this document.
2. Only use your ChargePAK with original Pure products.
3. Do not dismantle, open or shred ChargePAK.
4. Do not expose ChargePAK to heat or fire. Avoid storage in direct sunlight
5. Do not short‑circuit a ChargePAK. Do not store ChargePAKs haphazardly in a box or drawer
where they may short‑circuit each other or be short‑circuited by other metal objects.
6. Do not short‑circuit a ChargePAK. Do not store ChargePAKs haphazardly in a box or drawer
where they may short‑circuit each other or be short‑circuited by other metal objects.
7. Do not remove ChargePAK from its original packaging until required for use.
8. Do not subject cells or batteries to mechanical shock.
9. In the event of ChargePAK leaking, do not allow the liquid to come in contact with the skin or
eyes. If contact has been made, wash the affected area with copious amounts of water and
seek medical advice.
10. Do not use any charger other than that specifically provided for use with the equipment.
11. Observe the plus (+) and minus (–) marks on the ChargePAK and equipment and ensure
correct use.
12. Do not use any cell or battery which is not designed for use with the equipment.
13. Keep ChargePAK out of the reach of children.
14. Seek medical advice immediately if a cell or a battery has been swallowed.
15. Always purchase the correct ChargePAK for the equipment.
16. Keep ChargePAK clean and dry.
17. Wipe the ChargePAK terminals with a clean dry cloth if they become dirty.
18. After extended periods of storage, it may be necessary to charge and discharge ChargePAK
several times to obtain maximum performance.
19. Secondary cells and batteries give their best performance when they are operating at normal
room temperature (20 °C ± 5 °C).
20. Retain the original product literature for future reference.
21. Use only the ChargePAK in the application for which it was intended.
22. Dispose of ChargePAK properly.

PURE Jongo S3 Specifications

General

Speaker type	-
Woofer diameter	88.9 mm
Tweeter diameter	19.05 mm
Number of drivers	4
Number of speakers	1
Audio output channels	1.0 channels
Certification	CE, US FCC/ETL, C-Tick, ETSI EN 300 401
Recommended usage	Mobile phone / Smartphone
Audio formats supported	AAC, MP2, MP3, WMA
Subwoofer included	Yes
Impedance	- Ω
Frequency range	- Hz
RMS rated power	20 W
Product type	Mono portable speaker
Product color	White
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wired & Wireless
Power source type	AC, Battery

Weight and Dimensions

Depth	139 mm
Width	131 mm
Height	135 mm
Weight	1000 g