EasyManuals Logo

PURE Jongo T2 User Manual

PURE Jongo T2
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
EN
13
FCC NOTICE TO A USER IN THE UNITED STATES
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement
Caution: This Transmitter must be installed to provide a separation distance of at least 20 cm from
all persons.
IC NOTICE TO A USER IN CANADA
Since digital circuitry may cause interference to other radio or television tuners nearby, switch this unit
off when not in use or move it away from the affected radio/television tuner.
Note: This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus as set out in the Radio Interference Regulations of Industry Canada. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television operation (which
can be determined by turning the equipment off), the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio / TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Jongo_T2_T4_QSG-Bear-US-v1.indb 13 9/2/2014 11:32:19 AM

Other manuals for PURE Jongo T2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PURE Jongo T2 and is the answer not in the manual?

PURE Jongo T2 Specifications

General IconGeneral
Speaker type2-way
Number of drivers-
Number of speakers1
Audio output channels1.0 channels
CertificationCE, US FCC/ETL, C-Tick. ETSI EN 300 401
Recommended usageMobile phone / Smartphone
Impedance- Ω
Frequency range- Hz
RMS rated power- W
Product typeMono portable speaker
Product colorBlack, White
AUX inYes
Bluetooth profilesA2DP
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technologyWired & Wireless
Power source typeDC
AC adapter input voltage100 - 240 V
Weight and Dimensions IconWeight and Dimensions
Depth120 mm
Width250 mm
Height150 mm
Weight1104 g

Related product manuals