Place purifier in a
common room with
an HVAC return, as far from the
return and as high as possible.
Setup
Ionization, Electrostatic
Filtration and Photo-
Catalytic Oxidation are always on.
Use Control Panel or Remote to
change settings for Fan Speed
and Activated Oxygen.
Set Fan Speed as high as possible
without it being too noisy.
In PCO/Normal Mode, Activated
Oxygen is not produced.
In High Mode, Activated Oxygen is
scaled with the square footage
displayed on the screen. Start low
and increase gradually to match
the total area of your space.
In Away Mode, Activated Oxygen
runs at full blast for the time on the
screen. Use only in unoccupied space.
Use
To Next Page
