Need help?Do you have a question about the PureAir 3000 and is the answer not in the manual?
General| Technology | HEPA, Activated Carbon |
|---|---|
| Timer | Yes |
| Filter Type | HEPA filter, Activated Carbon filter |
| Control Type | Touch Panel |
| Filter Life | 6 months |
Identifies components on the front of the air purifier unit.
Identifies components on the side of the air purifier unit.
Identifies components on the rear of the air purifier unit.
Shows internal parts with the rear cover removed for clarity.
Details the PCO Cell and Purification Plate assembly.
Illustrates the DC power adapter and its cord.
Details the buttons and functions on the control panel and remote.
Explains the elements shown on the unit's display screen.
Illustrates how the display changes for different operating modes like PCO, High, and Away.
Instructions for removing the purifier and checking contents.
Guidance on selecting the optimal placement for the air purifier.
Steps for physically placing and connecting the purifier to power.
Explains the 'REPLACE CELL' notification and replacement procedure.
Details the 'PERFORM CLEANING' notification and cleaning process.
Connect power, turn on, and set to Normal (PCO) mode.
Run in Normal mode, then calibrate High mode by adjusting square footage.
Instructions for using the main operating modes of the purifier.
How to activate and use the Sleep mode for reduced light.
Tools, workspace, and steps to remove the rear cover.
Procedure for removing the filter assembly from the purifier.
Procedure for removing the purification plate and PCO cell.
Instructions for safely removing the front grille.
Steps to correctly install the front grille and PCO cell.
Guidance on properly inserting the purification plate.
Steps to correctly install the filter assembly and rear cover.
Connect power and turn on the purifier after assembly.
Procedures for cleaning the purifier's exterior, interior, and filter assembly.
Specific instructions for cleaning the ionization needle, PCO cell, and purification plate.
How to reset the 'PERFORM CLEANING' notification.
Diagnosing problems with the purifier not turning on or producing ozone.
Troubleshooting arcs, noises, odors from the plate, or a non-lighting PCO cell.
Resolving electrical arcs from the needle and fan operational problems.
Steps to identify the source of rattling noises.
Process for getting service and registering the product.
Details on warranty coverage limitations and exclusions.
Description of the Ozone Plate Cleaning Kit and its benefits.
Information on using pre-filters for harsh environments.
To Next Page
