10
Installation (cont.)
The display case should be located in such a manner that air will freely circulate
around the evaporative tray and rear of the case to avoid the formation of
condensation. A gap of 1 /2” (40mm) needs to be maintained to the rear of the
display case. The air must then be allowed to freely circulate either over the top of
the cabinet into the store, or (if it is large enough) into the ceiling void.
The finished backs on these cases and oversized end panels ensured adequate air
flow spacing
Failure to allow the air to escape may lead to Condensation and water pooling or the
cabinet tripping out on high pressure
Ensure that adequate refrigeration, electrical isolation and circuit
protection is incorporated within the final installation as necessary to
meet all relevant requirements and match the design criteria of the
supply systems.
Pure Cold Impact 6 Installation,
Operation & Maintenance Manual
To Next Page
Loading...