PUREWAVE CM-07 - Battery Life Details; Using the Pure-Wave Massager; Percussion Mode Operation; Facial Micro-Vibration Mode

4
5. Remove the CHARGER from Pure-Wave before use.
6. Pure-Wave is ready for use. See operating instructions.
■
Battery Life
1. Battery life: continuous use up to 180 minutes (if no load is applied).
2. Battery tests were done in the manufacturer’s facility with its own equipment. Battery life varies
depending on usage.
3. Batteries equipped : Built-in 7.2V Lithium-ion 2200mA 18650 2 Cell, 16.28 Wh. Replaceable by
manufacturer for a fee.
4. If the product is not in use for a long time, please keep its power o. Batteries will last longer if kept
recharged versus at a discharged state.
6. Please keep the massager away from heat and avoid using in places where the surrounding
temperature is relatively hot.
7. During storage keep the power o and store the product in a cool place.
Using Pure-Wave Massager
Pure-Wave is a dual motor massager and therefore has two operating modes activated by the On/O
Speed Dial. Only one mode will operate at a time.
■
Percussion Mode:
1. Remove CHARGER for operation.
2. Turn the On/O SPEED DIAL clockwise 180 degrees or until percussion motor engages. The percussion
side will generate a hammering motion which indicates it is working. The LED power light will be solid.
Set desired speed.
3. For user’s safety, the product may power o if too much load is applied. In this case, Pure-Wave may
need to be reset by plugging it into the charger for 3 seconds (see troubleshooting reset procedure).
■
Facial Micro-Vibration Mode:
1. Turn the On/O SPEED DIAL just slightly until you hear a beep. A second beep will sound and the LED
power light will start blinking. This indicates the micro-vibration mode is on. Set desired speed.
2. To re-initiate percussion mode, turn dial o and then back on turning clockwise until percussion mode
engages.
Pure Wave will not operate
while plugged into wall
outlet.
Percussion Motor
Facial Micro-Vibration
Motor
If the dial is not turned quickly to the right you may hear a 2nd beep which
means you have activated the facial micro-vibration mode.
On/O Speed Dial