12
Step 7: Next:
• Place the voltmeter negative
lead on the negative battery
post.
• Place the positive lead on the
circuit breaker closest to the
battery post.
• e voltage should read 13+
volts.
• If the voltage reads 13+, reset
the circuit breaker.
• If the voltage does not read
13+, the circuit breaker will
not reset. Replace the circuit
breaker.
Step 8: On the front of the trailer,
remove the hardware holding the
cover assembly to the nosebox
base.
• Place the voltmeter positive
lead where the black wire is
connected.
• Place the negative lead where
the white wire is connected.
• If there is a voltage reading,
inspect the wiring between
the battery box and the cover
assembly.
• If there is no voltage reading,
check the 30 amp fuse and
replace if blown.
To Next Page
Loading...
