3
VIDEO INSTRUCTIONS: WWW.PLBFUN.COM/PRISMIC
Join our community online:
Follow us @PLBFUN
WWW.PLBFUN.COM
4
VIDEO INSTRUCTIONS: WWW.PLBFUN.COM/PRISMIC
Join our community online:
Follow us @PLBFUN
WWW.PLBFUN.COM
5
A PRISMIC™ build can take some time and needs a clean
and flat surface where you can lay out the panels and have
enough room to work. A desk or large table is ideal.
For each step, there is a main layout of all the panels indicating
which to use for the step.
There is also a larger version of that same panel showing
the fold lines and which Edges connect to which Tabs (if
any on that panel), along with any additional notes for that
step.
GETTING STARTED
Start off by taking the Panels, Locking Pins and LED
Light Strings out of the package. Set the LED lights
aside. You won’t need them for a while.
Find a safe place on your workspace to place the
locking pins. You’ll need these on each step, so it’s a
good idea to keep them within easy reach.
Make sure that each panel matches the location
and shape exactly. Some panels look alike, even
when flipped over. To make sure your project goes
smoothly, match them exactly as laid out on this
diagram.
The panels have protective film on both sides of
the panels. You can remove it all now, making sure
you place the panels back in the correct position
before continuing. Alternatively, you can remove the
protective film at each step.
Double check that you have the panels in the correct
position before starting off, and if they are, it’s time
to get started with the assembly process!
1
2
Step 1
Take the panels and lay them out according to the diagram below. This will make it much easier to follow the steps for
the instructions. This diagram will be shown in each step of the instructions and used to show you your progress and
more easily identify the panels needed.
To fold each crease, secure one side of the crease between
one thumb and index finger and use your other hand to fold
the other side of the crease in the direction indicated.
The smaller creases will fold with one motion, whereas
the longer ones may need you to crease a couple of times
along its length until the panel starts to fold.
Remove plastic film
Start folding at one end of the panel and work your way to
the other side. When you reach the end of the panel, make
any indicated connections with the Locking Pins.
Make sure that the fold is consistent along the length of the
crease, so the edge is nice and even.
4
5
Remove protective film from both sides
of the panel before folding.
Outside of the panel is facing you. Inside
is down on the table.
RED = Fold up towards you
BLUE = Fold away from you
Flat Edges on outside of Tab
Locking Pins go from outside to inside
(pointy end in).
Before you start folding and bending the panels
remove the protective film from both sides of the
panel.
WWW.PLBFUN.COM/PRISMIC
REMEMBER THE BASICS:
To Next Page
Loading...