VIDEO INSTRUCTIONS: WWW.PLBFUN.COM/PRISMIC
Join our community online:
Follow us @PLBFUN
WWW.PLBFUN.COM
8
VIDEO INSTRUCTIONS: WWW.PLBFUN.COM/PRISMIC
Join our community online:
Follow us @PLBFUN
WWW.PLBFUN.COM
9
Step 8
Step 9
Step 10
Step 11
Take the piece you completed in Step 7 and join it to the
main assembly by connecting the flat and tabbed edges
as indicated below.
As you complete placing the string light inside your
PRISMIC™ make sure the string light is as evenly
distributed as possible, and there’s enough left over to
spread into the last arm of the star when you attach it in
the upcoming steps.
There is no right or wrong way to install the lights. The
panels will sparkle whichever way you place the lights
inside. The goal is to get them as evenly distributed as
possible.
The easiest way to do this is to gently uncoil the LED light
string into a looser bundle and gently and evenly distribute
the bundle throughout the inside of the PRISMIC™ leaving
just enough for the last section (which you’ll connect on
the next steps).
This last set of connections to the main assembly can be
a little tricky to complete. Take the piece from Step 10 and
attach it to the main assembly. Take your time and line
up the pieces well before starting the last connections
with the locking pins. Make the connections as indicated
below.
You should end up with something that looks like this:
With your PRISMIC™ Star nearly complete, this is a great
time to set up the LED light string inside the assembly.
The opening into the shape will give you access to all the
inside parts of the PRISMIC™ so you can spread the lights
string out inside it.
Pick up the highlighted panel.
Bend the red and blue edges accordingly and make the
connections in green.
You should end up with something that looks like this:
The last piece has a hole cutout in one of the panel sides.
Leave the connections closest to it for last. You can use
the hole to insert a finger into it to help push closed the last
locking pins.
As you do the last set of connections, make sure that
the LED string is entirely within the assembly of your
PRISMIC™. Adjust the wire so that it comes out of the
PRISMIC™ where indicated in the photo below if you want
to lean it on a shelf.
If you’d like to optionally hang your Star Lantern using the
included hook, make sure the LED string lead comes out
of the tip of one of the arms of the star (you may have to
open up a couple of the connecting pins to route the cable
more easily.
WWW.PLBFUN.COM/PRISMIC
WWW.PLBFUN.COM/PRISMIC
WWW.PLBFUN.COM/PRISMIC
WWW.PLBFUN.COM/PRISMIC
To Next Page
Loading...