SE: Search scan
The radio stops on a busy channel and exits the S
can mode.
Setting the VOX sensitivity level
The VOX function is deactivated by default. To activate it follow the procedure
here below:
1. press the MENU and ENT button to enter;
2. turn the Encoder knob until the display shows “VOX? 002” (menu 002);
3. push the ENT key;
4. turn again the Encoder knob and select the desired VOX level (you can
choose amongst 9 different levels);
5. push the ENT key again;
6. to exit, press VFO/MR
Setting the transmission power
To select desired power level:
1. press the MENU and ENT button;
2. turn the Encoder knob until the display shows “POW? 003” (menu 003)
3. push ENT;
4. turn again the Encoder knob and select the desired power level (you can
choose between 2 levels: ‘H’ and ‘L’);
5. press ENT
6. press the VFO/MR to exit
Setting squelch
To select the squelch level:
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘SQL? 004’(menu 004) is displayed
3. push ENTER;
4. turn the Encoder knob and select the desired squelch level (9 different
levels are available);
5. press ENTER
6. press the VFO/MR to exit
Scrambler Setting
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘SCRM ? 005’(menu 005) is displayed
3. push ENTER;
4. turn the Encoder knob to select ON or OFF.
5. press ENTER
6. press the VFO/MR to exit
To Next Page
Loading...
