1.
Press the MENU and ENT button;
2. rotate the Encoder knob until ‘S-D?’(menu 17) is displayed
3. push ENTER;
4. Turn the Encoder knob and select the repeater shift. You can choose amongst
the following options +, - and 0;
5. press ENTER again;
6. press the VFO/MR to exit
Wide and Narrow band selection
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘N/W?’(menu 18) is displayed
3. push ENTER;
4. turn the Encoder knob to select from NARROW or WIDE.
5. press ENTER
6. press the VFO/MR knob to exit
Automatic Numbering Identification (ANI) setting
You can set an automatic number identifier visible from the radio’s display of
your partner each time you send a call signal.
To activate it or select different mode:
1. press the MENU and ENT button;
2. turn the Encoder knob until ‘ANI’(menu 19) is displayed
3. push ENTER;
4. turn the Encoder knob to select ON/OFF
5. press ENTER
6. press the VFO/MR knob to exit
Identification code (ANI), can be programmed by software to two ways: ① Before
TX, ② End TX; There are two signaling for choose: MSK, DTMF
Note: item 16-19 insert by programming software, 16-17 only available in
frequency mode.
To Next Page
Loading...
