Pyle Pro PSS4 - PREPARATIONS; MAKING THE CONNECTIONS; Cautions

2
PREPARATIONS
•UsethePYLEPROSpeakerSelectorsonlywithamplifiersratedat100wattsper
channelorless.
•YourPYLEPROSpeakerSelectorisdesignedtoacceptanysizecableupto14gauge
non-terminatedspeakerwire.Ifyou’reusingnon-terminatedspeakerwire,donotuse
anyspeakerwirethatislargerthan14gauge.Thelowerthegaugenumber,thelarger
thecable(e.g.,12gaugeislargerinactualphysicalsizethan14gauge).
•Donothooktheoutputsofoneselectorintotheinputsofanotherspeakerselector
together.
MAKINGTHECONNECTIONS
Thecontrolcenterdividesthepowerfromyourreceiver/amplifierdifferentlytoits
speakerterminals.(Thisisespeciallynoticeablewhenyouconnectonlyonepairof
speakers.Ifyouconnectmorethanonepairofspeakers,see“ImpedanceChart”on
page5toselectorthebestterminalstoconnect.)Forthebestperformance,makethe
connectionsbasedonhowfrequentlyyouuseeachsetofspeakers.
Cautions:Toavoiddamagingyourspeakersorreceiver/amplifier:
•Besureyourreceiver/amplifier’spoweristurnedoffbeforeyoumaketheconnections.
•Neverletthespeakerwire’sbareendstoucheachotherortheadjacentterminalsonthe
controlcenter.
•Donotconnectmorethanonepairofsepakerstoeachsetofterminals.