Pyle Pro PSS4 - OPERATION

4
Notes:
•Ifyourreceiver/amplifierhasmorethanonesetofspeakerterminal(AandB),connect
onlyoneortheothertothecontrolcenter.
•Forthebestresults,werecommend14-gauge,twoconductorspeakerwire(not
supplied)formostconnections.Ifyouplantolocatedthespeakersfurtherthan80feet
fromthecontrolcenter,useaheaviergaugeofwire.
OPERATION
Caution:Toavoiddamagingyourreceiver/amplifier,setitsvolumetothelowestsetting
beforechangingthecontrolcenter’ssettings.
Toturnonapairofspeakersconnectedtothecontrolcenter,simplypressinthedesired
button.Forexample,toturnonthesetofspeakersconnectedtoSPKA,pressA.
Toturnoffapairofspeakers,pressthebuttonagainsoitisinthe“out”position.
Note:ifnospeakersareconnectedtoasetofterminals,donotpressinthecorresponding
controlbutton.