www.PyleUSA.com
4
TWS Function:
1. Turn ON two identical speakers you want to pair, please be noted that they
must have the same BT paring name, both under BT mode. You only need to set
up one of the two units;
2. Press “TWS” button for around 4 seconds, speaker will make a tone “di” to start
pairing, and will make “di” voice for 3 times once successfully paired;
3. Connect Wireless BT with your mobile phone to play music by the two paired
Speakers to create more powerful surround sound eect.
4. If you want to exit the TWS mode, press and hold “TWS” button (of the unit that
you set at beginning) again to exit the TWS function.
AUX-IN:
For other compatible music devices or your MP3/MP4 players, use the supplied
audio line cable to connect from the device’s “Line Out” to the “Aux In” of this
device. Then press the “MODE” button, the speaker will prompt “Aux Input Mode”,
then Enjoy.. When using an external device, all functions can be controlled by the
external device.
Remarks:
1. When using Wireless BT connection with iPhone mobile, there will be a battery
icon indicating the speaker battery volume on your iPhone.
2. Press the MODE button to switch for dierent modes, the order is Wireless BT,
USB disk, Micro SD, FM radio and AUX-IN.
3. When the speaker’s Wireless BT is connected with one mobile device, user can
press and hold the TWS button to disconnect the previous device, then make
Wireless BT connection with another mobile device;
4. Default volume is at 50% status of max volume;
5. Press and hold Mode button to turn the RGB on/o;
6. When battery voltage is low, the speaker will prompt “Battery Is Low, Please
Recharge In Time”;
7. Turn the power button to “o” while not in use.
To Next Page
Loading...
Need help?
General
