www.PyleUSA.com
5
MOUNTING
MOUNTING THE BRACKET:
1. Remove the bracket knobs and the bracket from the speaker.
2. Hold the bracket up to the mounting surface. The speaker can be mounted either horizontally
or vertically. Hold the bracket so that the speaker wire fits through the large, circular wire
hole in the bracket. Align the bracket to be square with the surroundings (use a level for
accuracy).
3. Mark the locations of the three shaped screw holes. Use all of the holes.
4. Drill pilot holes into the mounting surface.
5. Gently pull the speaker wire through the wire hole in the center of the mounting bracket.
Align the bracket so that the holes all line up.
6. Use your hardware to attach the bracket to the mounting surface.
FINAL ADJUSTMENTS:
1. After checking that the speaker is in-phase and works correctly, angle the speaker for the
best sound.
2. Hand tighten the bracket knobs only. Power tools may over-tighten the knob, and strip the
threads of the insert.
3. Check that the entire installation is safe and secure.
To Next Page
Loading...
Need help?
General
