05
JH-8013/JH8014 Manual
1 Transmitter、
2 Receiver、
3 Audio cable1、
6 Microphone、 cable
Model A
(for one receiver)
Model B
(for two receivers)
B. Product parts
JH-8013/JH8014 Manual
4 Audio cable2、
7 Wired headphone cable、
5 Optical fiber cable、
(for JH-8014A/B)
14
6. Computer chatting instruction
7. Charging instruction
There are two charging ways.
(1) Charging the receiver:
(2) Charging the battery in the charging compartment:
Place the receiver into the charging bay of the transmitter. The receiver can
only fit into the bay if its indicator faces the indicator of the transmitter.
Open the battery case of the receiver, pull out the Li-ion battery. Insert it into
the charging compartment at the side of the transmitter as shown below.
Switch off the receiver, and remain the transmitter on during charging.
(1) Plug the external microphone cable into the MIC socket of a computer and
clip the microphone on to your lapel close to your mouth.
(2) Connect one end of the wired headphone cable into the LINE-IN socket of the
receiver, and the other end into the headphone socket of the computer.
, then switch it on, adjust the
VOLume, TONE, BALance to your required levels.
Ensure
the volume on the receiver is set to the lowest
6.
It’s better that connect your
mobile phone to LINE-IN socket of the receiver by the wired headphone cable.
please face to the microphone of your mobile phone.
This function will only be suitable for the mobile phone that its network is
more than 2G.
Or use the receiver as a bluetooth earphone of your mobile phone.
Note: the speaker volume of the computer may need to be adjusted properly.
To Next Page
Loading...