Need help?Do you have a question about the Pyle PQA2100 and is the answer not in the manual?
Lists soft start, DC protection, over-current, cut-wave, and over-heat protection for PQA amplifiers.
Details on power switch, input level knobs, and status LEDs on the front panel.
Explains rear panel connectors, power input, fuse, and ground lift switch.
Provides solutions for issues like no sound, hum, distortion, and intermittent audio.
Lists soft start, DC protection, over-current, cut-wave, and over-heat protection for PQA amplifiers.
Details on power switch, input level knobs, and status LEDs on the front panel.
Explains rear panel connectors, power input, fuse, and ground lift switch.
Provides solutions for issues like no sound, hum, distortion, and intermittent audio.
General| Channels | 2 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | > 95 dB |
| Input Sensitivity | 0.775V |
| Type | Power Amplifier |
| Power Output | 1000W |
| Impedance | 4 Ohm |
| Input Impedance | 20 kOhm |
To Next Page
