7
SOLUTIONPROBLEM
LED is not on
No steam
Pale residue left on floor
Steamer is leaking water
=
Ensure auto shutoff feature has not been engaged.
Simply turn power button back on and proceed.
=
Ensure steamer power cord is correctly plugged into
a 120V AC power outlet only.
=
Ensure circuit breaker is operational.
=
Try operating steamer from another power outlet.
=
If unit is still not working, call customer service
at 1-888-318-PYLE / 718-535-1800.
=
Ensure water tank is full.
=
Calcium and mineral deposits can build up and
impact the performance of your steamer, use distilled
water if necessary.
=
This can be caused by leaving the steamer in the
same spot for too long. Residue can be removed with
household white vinegar or a decalcifying product.
=
Alternatively, reheat the area for one minute to
remove residue (do not overheat area.)
=
The microfiber cloth pad may be overused and
needs to be changed out with additional cloth pad(s)
provided. Cloth pads can be cleaned in washer/dryer.
Over time, however, the cloth pads can start to wear.
=
Be sure microfiber cloth pad is attached properly.
=
If the unit should continue to leak water, unplug and
wait 5 minutes before trying again.
TROUBLESHOOTING
CAUTION: Prior to cleaning or maintaining your steamer, isolate the unit
by removing the cord from the power socket.
To Next Page
Loading...