www.PyleUSA.com6 www.PyleUSA.com 7
TROUBLESHOOTING
Try the troubleshooting steps below if you are having problems while using your
speaker. If problems still exist, please look for a qualied technician or contact our
company. To prevent electric shock or expand the scope of the malfunction, do
not repair by yourself.
Features:
•
All-in-One Karaoke Entertainment System
• High-Powered Active Speaker Tower
• Multi-Colored DJ Flashing LED Lights
• Bluetooth Wireless Music Streaming
• USB Flash & SD Memory Card Readers
• Digital Audio File Support
• Includes Wireless Handheld Microphone
• FM Radio with Auto Station Scan
• (2) 1/4'' Microphone Inputs
• RCA (L/R) & Aux (3.5mm) Inputs
• Connect & Stream Audio from External Devices
• Convenient Carry Handles & Detachable Rolling Wheels
• Treble, Bass, Echo, Volume Controls
• DJ Party Lights ON/OFF Switch
Technical Specs:
• MAX Power Output: 2000 Watt
• Sound System: Dual 10'' Woofers, Dual 3'' Tweeters
• Frequency Response: 45Hz-20kHz
• Sensitivity (1w/1m): 92dB
• Impedance: 4 ohm
• Maximum SPL: 128dB
• Dispersion (@6dB): H90°X V50°
• Crossover: 3 KHZ
• Power Supply: 110/220V
• Microphone Battery Operated: Requires (2) x 'AA' Batteries, Not Included
• Maximum USB Flash / SD Memory Card Support: 32GB
• Dimensions: 16.1'' x 15.1'' x 42.0'' -inches
SYMPTOM POSSIBLE PROBLEM SOLUTION
No function light
and No sound
1. Plug is not well connected
2. Speaker power button is
not turned on.
1. Insert the plug into electrical
outlet.
2. Turn on the power button
Function light is
turned on but no
sound
1. Cable misconnected
2. Speaker are not connected
or misconnected
3. Audio signal is not trans-
mitted to speaker
1. Turn o the power, check the
input jack to ensure proper
audio signal is connected to
relevant input jack
2. Power o, then check and
conm the cable connection
again.
3. Check all the speaker if there
is audio signal output
Remote control
does not work
1. Before you press any function button, rst select the correct
source with the remote control instead of the main unit
2. Reduce the distance between the remote control and unit
3. Insert the battery with its polarities (+/-signs) aligned as
indicated
4. Replace the battery
5. Aim the remote controldirectly at the sensor on the front
of the unit.
If the problem exists after checking related procedures above, please refer to
the appointed service ... Do not attempt to open the cover, otherwise we
assumes no responsibility
To Previous Page
Loading...
