EasyManua.ls Logo

Pyle Pure Clean PUCWM22 User Manual

Pyle Pure Clean PUCWM22
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
If the spin dryer does not work, check if:
The inner lid and outer spin bowl lids are closed.
The spin dry timer is set.
If there is excessive noise, check if:
Something is touching the pulsator as it rotates.
The machine is not placed on a level surface.
The wash load does not exceed more than the machine
can handle to ensure balance during the spin cycle.
Something is stuck between the spin bowl and tub.
Wash Day Maintenance
At the end of the day:
Unplug the power cord from the outlet.
• Check that both timers are set to the OFF position "O"
• Wipe the inside and outside of the unit with damp clean cloth.
• Remove the hose from the water tap.
TWIN TUB WASHING MACHINE
Please read the manual carefully before using the machine
CLEANING AFTER USE
Always clean the washing machine after every use. Ensure the power switch is
turned off and disconnected from the electrical outlet before performing this action.
POINTS TO REMEMBER
Avoid using excessive amounts of bleach or detergent; use the amount of soap
recommended by the manufacturer.
• For your safety, ensure that the ground connection is correct.
• Never put your hands into the spin tub while operating.
• When washing, the water temperature should be below 120°F. This is to prevent
the plastic components from being deformed.
• Do not place the washing machine close to heat generating products such as gas
or electric cookers.
• Use soft cloth when cleaning the washing machine to prevent damages on the
surface of the cabinet.
• Do not place wet load on the control panel.
• Do not place washing machine outside or in a damp area.
BEFORE YOU CALL FOR SERVICE
• If you suspect the washing machine requires maintenance, follow these instructions
to save unnecessary costs before calling the manufacturer or a technician.
• If the washing machine will not start, check if:
o The hose circuit breaker is tripped or a fuse is blown.
o The cord is firmly connected to the power point or the power is not switched “ON”.
o Something is stuck and is preventing the pulsator from rotating.
o The wash timer is set.
TABLE OF CONTENTS
Contents Page
Parts Identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Chief Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Operation Instruction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4
Laundry Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Cleaning After Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Point To Remember . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Before You Call For Service . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Maintenance After Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
INSTRUCTION MANUAL
PUCWM22
Question and Answer IconNeed help?

Do you have a question about the Pyle Pure Clean PUCWM22 and is the answer not in the manual?

Pyle Pure Clean PUCWM22 Specifications

General IconGeneral
Load Capacity (Wash)7.7 lbs
Weight28.6 lbs
Washer TypeTwin Tub
Voltage110V
ColorWhite
MaterialPlastic
Frequency60Hz
TypePortable Washer

Summary

Wash Day Maintenance

Daily Maintenance Routine

Steps for maintaining the washing machine at the end of each day, including unplugging and cleaning.

Before You Call For Service

Parts Identification

Installation

Electrical Connection

Details on how to properly connect the washing machine to a power source.

Connection of Water Inlet Hose

Instructions for attaching the water inlet hose to the machine.

Operation Instruction

Preparing the Wash

Steps to prepare laundry and the machine before starting a wash cycle.

Spin Drying

Detailed steps for operating the spin drying function safely and effectively.

Warning

Related product manuals